PIC16C63A-04I/SO【PDF 17/184 页】IC MCU OTP 4KX14 PWM 28SOIC

收藏本站

您好，
买卖IC网欢迎您。
请登录
免费注册

买卖IC网

Sheet目录3841

13页 14页 15页 16页 [17页]18页 19页 20页 21页

113

SAM7S Series [DATASHEET]

6175M–ATARM–26-Oct-12

When the bit is set, the bit FRDY in the Flash Programming Status Register (MC_FSR) rises. If an interrupt has

been enabled by setting the bit FRDY in MC_FMR, the interrupt line of the Memory Controller is activated.

Two errors can be detected in the MC_FSR register after a programming sequence:

Programming Error: A bad keyword and/or an invalid command have been written in the MC_FCR register

If the general-purpose bit number is greater than the total number of general-purpose bits, then the command

has no effect.

It is possible to deactivate a general-purpose NVM bit set previously. The clear sequence is:

Start the Clear General-purpose Bit command (CGPB) by writing the Flash Command Register with CGPB and

the number of the general-purpose bit to be cleared in the PAGEN field.

When the clear completes, the bit FRDY in the Flash Programming Status Register (MC_FSR) rises. If an

interrupt has been enabled by setting the bit FRDY in MC_FMR, the interrupt line of the Memory Controller is

activated.

Two errors can be detected in the MC_FSR register after a programming sequence:

Programming Error: a bad keyword and/or an invalid command have been written in the MC_FCR register

If the number of the general-purpose bit set in the PAGEN field is greater than the total number of general-

purpose bits, then the command has no effect.

The Clear General-purpose Bit command programs the general-purpose NVM bit to 0; the corresponding bit

GPNVM0 to GPNVMx in MC_FSR reads 0. The Set General-purpose Bit command programs the general-purpose

NVM bit to 1; the corresponding bit GPNVMx in MC_FSR reads 1.

Note:

Access to the Flash in read mode is permitted when a Set, Clear or Get General-purpose NVM Bit command is

performed.

19.2.4.5

Security Bit

The goal of the security bit is to prevent external access to the internal bus system. (Does not apply to EFC1 on

theSAM7S512.) JTAG, Fast Flash Programming and Flash Serial Test Interface features are disabled. Once set,

this bit can be reset only by an external hardware ERASE request to the chip. Refer to the product definition sec-

tion for the pin name that controls the ERASE. In this case, the full memory plane is erased and all lock and

general-purpose NVM bits are cleared. The security bit in the MC_FSR is cleared only after these operations. The

activation sequence is:

Start the Set Security Bit command (SSB) by writing the Flash Command Register.

When the locking completes, the bit FRDY in the Flash Programming Status Register (MC_FSR) rises. If an

interrupt has been enabled by setting the bit FRDY in MC_FMR, the interrupt line of the Memory Controller is

activated.

When the security bit is active, the SECURITY bit in the MC_FSR is set.

发布紧急采购，3分钟左右您将得到回复。

采购需求

(若只采购一条型号，填写一行即可)

*型号	*数量	厂商	批号	封装

添加更多采购

采购需求

发布成功！您可以继续发布采购。也可以进入我的后台，查看报价

发布成功！您可以继续发布采购。也可以进入我的后台，查看报价

我的联系方式